Remove dirt, grease, curing residues and coatings that block absorption. Leave the concrete clean, dry and absorbent; check uniform wetting with a light water spray.

Use as supplied; do not dilute. Mix or stir thoroughly before application.

On horizontal surfaces, apply enough product to keep the surface wet for 2–3 minutes. Broom out puddles and wipe away excess. Dense surfaces need a single coat with no excess or runs.

Touch-dry in about 1 hour. Protect from rain for at least 6 hours and traffic for 24 hours. Water repellency develops over several days. Clean equipment with warm soapy water.

Remove dirt, grease, curing residues and coatings that block absorption. Leave the concrete clean, dry and absorbent; check uniform wetting with a light water spray.

Use as supplied; do not dilute. Mix or stir thoroughly before application.

On vertical porous surfaces, saturate from bottom to top with a 15–20 cm rundown; allow 5–10 minutes to penetrate and repeat wet-on-wet if needed, using less product. Dense surfaces need a single coat with no excess or runs.

Touch-dry in about 1 hour. Protect from rain for at least 6 hours and traffic for 24 hours. Water repellency develops over several days. Clean equipment with warm soapy water.