37 – 75 m² / L

60 – 100 m² / L

100 – 120 m² / L

Remove all foreign materials including bond breakers, curing agents, surface grease, and construction debris. (Best results achieved with an auto-scrubbing machine)

Stir or mix well. Do NOT dilute or alter.

*Estimated coverage rates vary, depending on concrete finish.

Lightly wet a clean microfiber pad with C2 Protector™ leaving a damp pad.

Using a clean pump-up sprayer, and working from one control joint to another, apply a light, fine spray of C2 Protector™ to a small section of the floor.

Using the damp microfiber pad and frim downward pressure, immediately spread C2 Protector™ to produce a thin, even application. Spread as far as possible while maintaining a wet edge.

Let treated and cleaned surfaces dry for 60-90 minutes. Best results are achieved when C2 Protector™ is allowed to dry for 4 hours.

If higher sheen is desired, once dry, burnish concrete with high-speed equipment, fitted with a C2 Heat burnishing pad or #1,500 - #3,000 grit diamond impregnated pad suitable for use on high- gloss finishes. C2 Protector™ does not need to be burnished to perform properly.

For maximum protection, apply a second coat and repeat steps 2-8 above.

C2 Protector™ may be applied over C2 Seal™ for added stain protection. C2 Seal™ must be left to cure minimum 24 hours before C2 Protector™ application.

37 – 75 m² / L

60 – 100 m² / L

100 – 120 m² / L

Remove all foreign materials including bond breakers, curing agents, surface grease, oil and construction debris.

Allow surface to dry before application.

Stir or mix well. Do NOT dilute or alter.

Using a clean low pressure pump-up sprayer, apply uniformly, using enough C2 Protector™ to saturate the surface .

Apply C2 Protector™ from bottom of surface to top to avoid product runoff.

Brush or roll out heavy runs or drips thoroughly for uniform coverage.

Let treated and cleaned surfaces dry for 60-90 minutes.

A second coat can be applied for maximum protection.