Remove all foreign materials including bond breakers, curing agents, surface grease, and construction debris. (Best results achieved with an auto-scrubbing machine)

*Dilute C2 Hard Blend™. Mix or stir well.

Estimated coverage rates 10-20 m²/L. Coverage rates vary, depending on density and porosity of concrete.

Using a low-pressure sprayer, apply a single coat of C2 Hard Blend™ evenly enough to wet the surface, avoiding puddling.

Pre-wet a clean microfiber pad and spread product evenly and ensure uniform wetting. Avoid overlap marks and streaks.

Be sure to maintain a wet edge when applying and avoid spreading when drying begins.

Surface should remain wet for 10-15 minutes.

Let treated and cleaned surfaces dry for 1 hour.

If higher sheen is desired, once dry, burnish concrete with high-speed equipment, fitted with an #800 level diamond impregnated pad. C2 Hard Blend™ does not need to be burnished to perform properly.

For increased hardening and sheen, apply second application and continue with #1500 level diamond impregnated pad.

Sand, level, or grind the concrete surface with a floor sander, orbital floor machine or diamond grinding as needed to achieve desired exposure. Grind floor to #200 grit resin bond diamonds.

Remove all dust and debris using a floor scrubbing machine and fresh, clean water.

Allow surface to dry before application.

*Dilute C2 Hard Blend™. Mix or stir well.

Estimated coverage rates 10-20 m²/L. Coverage rates vary, depending on density and porosity of concrete.

Using a low-pressure sprayer, apply a single coat of C2 Hard Blend™ evenly enough to wet the surface, avoiding puddling.

Pre-wet a clean microfiber pad and spread product evenly and ensure uniform wetting. Avoid overlap marks and streaks.

Be sure to maintain a wet edge when applying and avoid spreading when drying begins.

Surface should remain wet for 10-15 minutes.

Let treated and cleaned surfaces dry for 1 hour.

Grind with #400 grit resin bond diamonds

For increased hardening, apply a second light application of C2 Hard Blend™, allow to dry and continue to polish to desired level.

Dustproofing can be achieved on fresh or old concrete.

*Diluting C2 Hard Blend™ is not necessary for dustproofing.

Remove all foreign materials including bond breakers, curing agents, surface grease, and construction debris. (Best results achieved with an auto-scrubbing machine)

Allow surface to dry before application.

Using a low-pressure sprayer, apply a single coat of C2 Hard Blend™ evenly enough to wet the surface, avoiding puddling.

Pre-wet a clean microfiber pad and spread product evenly and ensure uniform wetting. Avoid overlap marks and streaks.

Be sure to maintain a wet edge when applying and avoid spreading when drying begins.

Surface should remain wet for 10-15 minutes.

Let treated and cleaned surfaces dry for 1 hour.